Modifying an event

You can modify an event by changing the event title, recording channel, clip location, router source, timing information, add a backup for the existing event or link the event to a placeholder.

Select the event you want to modify on the Scheduler tool.
Do one of the following:
- Click the Modify Event button. ( M)
- Right-click and select Modify Event.
The event opens in the Inspector panel.
If the event is part of a series, a dialog box pops up asking if you want to modify this occurrence or the entire series. Select the one you want to modify and click OK.
Event properties display in the Properties tab of the Inspector.
Modify the event properties.
If the event is created on a Multicam channel, two router sources appear for the event in the Inspector.
To set as a recurring event, click on the Misc tab and edit event properties.
To link the event to a placeholder, select a placeholder on the Link to Placeholder tab and click the Link button.
Note: Link to a placeholder is not supported for recurring events.
Click the Modify button on the Properties tab.

The event updates with those changes on the Scheduler tool.

Note: When double-click an event or drag it into the Inspector panel, the Inspector loads properties of assets. If then linked to a placeholder, the clip will not be renamed according to the placeholder's title. Make sure that you follow the exact steps in this topic to modify event in the Inspector and link to a placeholder.