[Workflow]: On‑Going Operations—Operator
iControl allows you to initiate a comparison between signals of probed sources and one from the reference source, as well as monitor and analyze comparison data. This feature relies upon the generation of signal fingerprints by supported Densité cards. A probed or referenced Densité card’s service subsequently sends the fingerprint to interested system entities.
IMPORTANT: Who performs these tasks? |
This section contains procedures typically performed by an operator. Before beginning these procedures, the initial configuration tasks must be completed—typically done by an administrator (click HERE). |
IMPORTANT: Maximum recommended number of fingerprint channels |
Make sure your system does not exceed the maximum recommended number of fingerprint channels according to your hardware specifications (click HERE). |
|
For more information about fingerprint comparison and analysis, including an overall workflow, click HERE. |
A sample monitoring and analysis workflow is as follows:
Monitoring and analysis tasks
1. | Start a fingerprint comparison for your comparison group ( click HERE). |
2. | Monitor fingerprint comparison data in real-time ( click HERE). |
3. | If desired, and when the required amount of time has passed, stop the fingerprint comparison ( click HERE). |