Configuring a Source as the Reference Source in a Comparison Group
IMPORTANT: The reference source you select should come from a point in the signal path where the fingerprint is known to be acceptable. In addition, the reference source should be upstream of the probed source(s) in the signal path. |
REQUIREMENTS: |
Make sure you meet the following conditions before beginning this procedure: |
• You have opened Audio Video Fingerprint Analyzer ( click HERE). |
• There are currently no comparisons underway for the comparison group you would like to edit. |
• [RECOMMENDED]: You are performing this procedure as a task within the context of an approved workflow ( click HERE). |
1. On the Configuration tab, in the Fingerprint comparison setup area, expand the comparison group folder representing the group whose source you would like to configure as the reference.
[ Graphic ]
2. Right-click the source you would like to configure as the reference, and then click Set as reference source.
System Response: The desired new reference source’s name becomes italicized and the former reference source’s name is no longer italicized.
NOTE: An italicized source name indicates a source is configured as the reference. |
System Response: An asterisk (*) appears next to the name of the comparison group indicating pending changes.
3. Click Apply all to save changes to the comparison group.
System Response: The asterisk next to the comparison group name disappears indicating all changes are now saved and saved to the group.
