Removing a Custom SNMP Driver from an Application Server
REQUIREMENT: |
Before beginning this procedure, make sure you have opened the GSM Alarm Browser of the Application Server ( click HERE). |
1. In the GSM Alarm Browser, if there is a left pane with a list of Application Servers, select the Application Server where the driver you would like to remove is located.
2. In the right pane, click the Admin tab, then click the SNMP Driver Creator tab.
[ Graphic ]
System Response: The SNMP drivers created in SNMP Driver Creator are listed.
3. Select the driver you would like to remove from the Application Server, and then click Remove.
[ Graphic ]
System Response: A confirmation message appears.
4. Verify this is the driver you would like to remove.
If this is the driver you would like to remove, click Yes.
If this is NOT the driver you would like to remove, click No.
