Rolling Back a Card’s Installed Package to the Pre-Upgrade Version
Perform this procedure if, after installing a package on a Densité card, you decide to restore both the firmware and software of the card to their respective pre-installation versions.
NOTE: In the case where you are rolling back a package installation resulting from a Force upgrade operation, the rollback operation effectively becomes a Force rollback operation. That is, even though the firmware currently installed and the firmware you are rolling back to bear the same version number, the rollback will proceed. |
REQUIREMENTS: |
Make sure you meet the following conditions before beginning this procedure: |
• You have opened Densité Upgrade Manager ( click HERE). |
• The Densité cards whose firmware and software you would like to downgrade are visible in Densité Upgrade Manager. |
• The package you would like to use to downgrade your Densité card has already been uploaded to your Application Server ( click HERE). |
1. In Densité Upgrade Manager, in the row corresponding to the card whose installed package you would like to roll back, select Rollback <version #> in the Available package column.
[ Graphic ]
System Response: The Select/Bypass check box for that card is selected, indicating that this card will undergo a change in its installed package, and the rollback path is indicated in the Installed package column.
[ Graphic ]
Rollback package selected for card installation (note the rollback path)
2. Click Upgrade.
[ Graphic ]
System Response: The rollback operation begins. You can monitor the progress of the rollback with the progress bar in the Install progress column.
[ Graphic ]
When the rollback operation is complete, the Install progress column displays a success message.