[Workflow]: Initial Setup—Administrator
iControl allows you to configure settings for the fingerprint analysis feature. This feature relies upon the generation of signal fingerprints by supported Densité cards. A probed or referenced Densité card’s service subsequently sends the fingerprint to interested system entities.
IMPORTANT: Who performs these tasks? |
This section contains procedures typically performed by an administrator. These procedures are generally configuration tasks that must be completed before an operator can begin a fingerprint comparison (see the sample configuration workflow, below). However, several configuration tasks are possible during and after the operator performs a comparison. |
IMPORTANT: Maximum recommended number of fingerprint channels |
Make sure your system does not exceed the maximum recommended number of fingerprint channels according to your hardware specifications (click HERE). |
|
For more information about fingerprint comparison and analysis, click HERE. |
A sample workflow of initial configuration tasks is as follows:
Initial configuration tasks
1. | Enable the Audio/Video Fingerprint Analyzer Service on your Application Server ( click HERE). |
2. | Open Audio Video Fingerprint Analyzer ( click HERE). |
3. | Configure Fingerprint Analyzer Service alarms according to your individual needs ( click HERE). |
4. | Create a comparison group of input sources, including a reference source ( click HERE). |
5. | Assign all desired input sources (including the reference source) to your comparison group ( click HERE). |
6. | Designate one of the assigned sources as the Reference ( click HERE). |
7. | Configure each assigned source’s channel assignments, as required ( click HERE). |