Editing an Alarm Map, Trap Map, or Poller Profile
You can edit alarm map, trap map, and poller configuration data after an initial configuration is performed. The following procedure details steps for an alarm map. However, the procedures for editing trap maps and pollers are principally the same.
REQUIREMENTS: |
Make sure you meet the following conditions before beginning this procedure: |
• You have opened SNMP Driver Creator ( click HERE). |
• You have loaded a MIB module into SNMP Driver Creator ( click HERE). |
• You are displaying the Alarms tab in SNMP Driver Creator. |
• You have configured your driver settings ( click HERE). |
• The alarm map you would like to edit is visible in the Alarm maps area on the Alarms tab of the SNMP Driver Creator. |
1. In the SNMP Driver Creator window, in the Alarm maps area, select the map you would like to edit.
2. Click Edit.
[ Graphic ]
System Response: The Edit Alarm Map window appears.
[ Graphic ]
3. Modify alarm map parameters as required, including the map name, mapping type, and editing, adding, or deleting mapping rules.
|
For more information about adding mapping rules, click HERE. |
