Safety Precautions

Follow these guidelines to avoid damage to the product or injury to yourself:

• Pay attention to all cautions and warnings on the equipment or in the manuals.
• This equipment is intended for installation in a Restricted Access Location. A restricted access area can be accessed only through the use of a special tool, lock and key, or other means of security. Allow only trained and qualified personnel should be allowed to install, replace, service, or operate this equipment.
• There is the danger of explosion if the battery is replaced incorrectly. Replace the battery only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer's instructions.
• Installation of the equipment must comply with local and national electrical codes.
• Always use properly grounded, unmodified electrical outlets and cables, capable of supplying the proper voltage and current.
• If an AC power cord was not provided with your system components, purchase one that is approved for use in your country or region.
• Be aware of the ampere limit on any power supply or extension cables being used. The combined total ampere rating of all devices on a circuit may not exceed 80% of the maximum limit for the circuit.
• Maintain reliable grounding of rack-mounted equipment. Pay attention to supply connections other than direct connections to the branch circuit (e.g., use of power distribution units). Failure to properly ground the rack may result in electric shock and injury.
• The power supply cord(s) is / are the main disconnect device to AC power. The socket outlet(s) must be near the equipment and readily accessible for disconnection.
• Whenever you are servicing the unit, completely power down the unit by turning off all power and unplugging all power cables. The power switch is not the main power disconnection device.
• When installing a hot-swappable power supply into your system, make sure that the power supply is fully installed before you connect power cables to it. When uninstalling a hot-swappable power supply from your system, unplug the power cable before removing the power supply.
• Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s instructions.