-
Click CONFIGURATION on the top bar,
then select Storage on the left-side bar.


The graphic will show the Primary Chassis and any attached Expansion Chassis.

Note: If Expansion Chassis has drives that look configured already (shaded same blue as
Primary Chassis shown in red below), the expansion will not work. See the
Troubleshooting section or SFDC knowledge base articles for potential fix.

Under Expansion Chassis, the status should be ‘Unconfigured’ as
shown in the yellow box below.

-
Click the ADD RAID SET button.
A series of dropdowns appears.

-
Enter the following values to add the first six drives (#1-6) to the LUN:
-
Click APPLY.
A provisioning task will be generated and shown with a PENDING status. (it could
take up to 5 minutes)

Once executed successfully, the status will change to SUCCESS and the graphic
will show the added drives.

-
Next, add the second six drives (#7-12) to the same array by clicking the
ADD RAID SET button again.
-
Enter the following values to add the second six drives (#7-12) to the LUN:
-
Click APPLY.
A provisioning task will be generated and shown with a PENDING status.
Once executed successfully, the status will change to SUCCESS and the graphic
will show all drives added.

This concludes the provisioning of the first Expansion Chassis. If more than one Expansion
Chassis is attached to the Primary Chassis, repeat the steps above to add additional RAID
sets, being careful to change the HBA Enclosure ID each time to be in the order attached to
the Primary Chassis.
When finished adding Expansion Chassis, log out of the AMS-GUI from the upper right-hand
corner (click the user profile icon).
