Configuring the Audit Dialog

The tab of the configuration dialog controls the amount of information that is stored in the audit log of the application. This log allows detailed information about the operation of the application.

Select Configuration> CommandCenter Configuration and click the Audit tab.

Audit Log Settings

UDP Logging

These checkbox controls the level of data for the UDP protocol layer. Normally set to Error only.

ACP Logging

These checkbox controls the level of data for the ACP protocol layer. Normally set to Error and Warning only.

Application Logging

These checkbox controls the level of data stored for the Application layer. Normally set to Error and Startup only.

Third-Party Protocol Logging

These checkbox controls the level of data stored for the third party protocols. Note this option is not port or protocol specific so it will log for all currently enabled third party protocols, the Raw option should be used for short periods of time if fault finding. This is Normally set to Error and Startup only.

Macro Logging

Select this option to log macro logging error messages.

Clear Audit Log

This button clears all the historic data from the audit log. The check box option allows the historical log data to be cleared every time the application is started.

Application Logging

These options allow you to specify application logging preferences.

Save Detailed Application Information

Select this option to save detailed application information.

Macro Message Logging (resets on restart)

Select this option to log macro messages.

Macro Action Logging (resets on restart)

Select this option to log macro actions.