Accessing CClink Status Information

The CCLink feature is used to configure the CommandCenter server application to communicate with CommandCenter client applications.

Configuration of the CCLink protocol information is done in the CClink tab:

Select Configuration>CommandCenter Configuration. The CCLink Configuration dialog displays.

Be sure that the CCLink protocols are configured correctly for your environment. For information see the "Configuring the CCLink Dialog" topic in the Dialogs section.

Note: When deploying a multi-client/server CommandCenter system, the server becomes a single point of failure for multiple workstations. To protect against this, there is a cost option for CommandCenter to enable redundant servers. If this cost option has been enabled on the CommandCenter hardware key, this checkbox can be checked to allow configuration of the redundant system.

You may use the CommandCenter Link Protocol statistics and Event Log can provide useful information in case of problems. Use the CCLink Protocol statistics and the Event Log to view device messages that can alert you to any potential problems.

To access the CCLink Protocol Statistics dialog, select the node in the System View and select Device View. The CommandCenter Link Protocol statistics dialog displays:

The CCLink Protocol Statistics dialog details the client connections and statistics of the CommandCenter communication protocol (CCLink), this is only used when enabled and running in the client/server modal.

To access the Event Log from the CCLink Protocol Statistics dialog, click the Event Log tab.