Configuring the Router Dialog

This tab of the configuration dialog is only shown when the Router Control option is enabled.

• Select Configuration> CommandCenter Configuration and click the Router tab.

Router

This tab of the configuration dialog is only shown when the Router Control option is enabled.

Treat Partial Connection As (If Redundant):

This option dictates the status severity in the event of CommandCenter finding that only a single connection is available to a device that has two IP addresses.

Auto-Correct Partial Connection

This option when checked means that any pre-existing warning/s or error/s in the event view for partial connection will be automatically acknowledged or cleared when both connections return.

Treat No Connection As:

This option dictates the status severity in the event of CommandCenter finding that a connection could not be made to this device.

Auto-Correct No Connection

This option is the same as Auto-Correct Partial Connection but for the No Connection events.

Re-assert Routes

Select this option to re-assert routes.