Router Control Considerations

The router configuration tasks cover how to install a router into Command Center and how to configure and control it. The Encore and Jupiter configuration can be more involved; especially if this is an existing system in which case the naming conventions should match those in the exiting Router Control Engine (RCE).

The existing RCE (Encore or Jupiter) must currently be used to control these functions:

  • Source Exclusions (Only supported by the RCE)
  • Tie Lines (Only supported by the RCE)
  • Salvos (Supported by the both but with differences)
  • Monitor Control
  • Visual Status Display
  • Areas
  • Automation or other external control (only supported by the RCE)

© 2014 Grass Valley USA, LLC. All rights reserved. Grass Valley is a registered trademark of GVBB Holdings S.a.r.l.