Using XY Mode

This mode is selected by default when the panel initially starts. It can also be selected from the main menu by pressing the “XY Mode?” button.

In this mode, each button represents a different destination. The destination mnemonic is shown on the bottom line of the LCD button. The current source for that destination is shown on the middle line.

The knob on the right can be used to scroll through additional pages of destinations.

To route a source to a particular destination:

  1. Press the button corresponding to that destination. The panel switches to a source selection mode.
  2. Find the button representing the source (you can use the knob to scroll through additional pages).
  3. Once found, press the desired source button. The source will immediately be taken to the selected destination. The button highlights for a few seconds to show that a take has been made:

    If a particular destination is locked, the button will light red and the owner of the lock will be displayed on the top line of the button.

    Note: It is not possible to select a preset source, or configure a breakaway in XY Mode.

Parent topic: Using LCD16 and LCD48 panels

© 2014 Grass Valley USA, LLC. All rights reserved. Grass Valley is a registered trademark of GVBB Holdings S.a.r.l.