Adding a Router

  1. From System View, select the Network menu.
  2. Select Add Network Device, Add Routing Device

  3. Select the type of router being added. Grass Valley products use one of three choices: ES switch, Jupiter or Native protocol (Encore). You may also choose another generic router. Ton install a simulated router, select Virtual Router.
  4. Choose Ethernet or Serial Control.
  5. Name the device – the device name or IP can be used to select the device to be controlled. The default name is ‘ROUTER’!
  6. Enter the Primary and Secondary IP addresses (if used).
  7. Under ‘Advanced Settings’ enter additional information to determine how the Router is going to be controlled.
  8. For Advanced IP Settings enter the port number if a port other than the default is required.
  9. The Maximum Router size and Number of Levels should be entered. This determines the number of Sources, Levels and Destinations that can be controlled.
  10. Retrieve Mnemonics and Locks are normally checked so that restarting CommandCenter will update any Router information in case it has changed.
  11. Set up SNMP info (if known).

© 2014 Grass Valley USA, LLC. All rights reserved. Grass Valley is a registered trademark of GVBB Holdings S.a.r.l.