Testing the Router Panel Controls

This final step will make the associated panel (if it exists) active and if it is connected to the router put it in control of the router.The test mode also will control the router if connected, without having any panel on line. This final step in testing involves adding a ‘Take’ button to allow the sources to switch.

  1. Choose the button on the panel.
  2. From Update Editor, right click and select Add Template>Router Panel Controls>HW Take Selection.
  3. Save the template.


© 2014 Grass Valley USA, LLC. All rights reserved. Grass Valley is a registered trademark of GVBB Holdings S.a.r.l.