Modifying Lever Arm Calibration Properties

You may monitor lever arm properties including the lever arm take point and the frame duration. The initial lever arm setup is saved and you do not have to recalibrate the system with every subsequent power on. But, if you think the Lever Arm needs to be recalibrated, for example, if you see a transition that jumped or failed to complete before the Lever Arm completed its transition. The, you can perform a new calibration here. You may also use this screen to set the lever arm’s frame duration (the number of frames per transition).

From the radial menu, select Transition Properties. The Transition Properties lever arm screen displays.
Set the lever arm take point. This is where you start to put the transition to air.
Set the lever arm’s frame duration (the number of frames per transition). Select Frame Duration.
Enter the number of Flash Frames and select Save.