Assemble GV Director Server Rack Trays

Adjustable server rack tray assemblies are provided with the GV Director Server and used to support the server in a rack. There are left and right rack trays that must be assembled prior to installation.

1. Align the rear rack tray with the front rack tray (right front with right rear or left front with left rear) so the adjustment slots line up and the front rack tray with the server support bracket is facing inward as it would in a rack holding a server. There is a front and rear rack tray for both the Left and Right rack tray assemblies and these must match to correctly support the server.
2. With the center adapter positioned on the outside of the rack tray assembly (rear bracket side) insert the four 6/32x1/4 inch flat head screws through the adjustment slots (two screws per slot) from the inside (side with the server support bracket).
3. Thread each of the four flat head screws into the center adpater's four self-clinching nuts, leaving each slightly loose for adjustment in the rack. Leaving the four flat head screws loose will allow for front-to-back adjustment when installing the rack tray assembly into a rack.
4. Repeat the preceeding steps for the opposite rack tray assembly.