Replacing the AJA card with the Mellanox card
- Make sure the recovery image has been created for GV I/O and saved into the USB Recovery Flash Drive.
For UHD workflow, the AJA card in your GV I/O must be replaced with the Mellanox
ConnectX-5 25 GigE card as the workflow is only supported on a GV I/O system with IP
option.
- Power down the GV I/O unit.
- Disconnect power cables from the GV I/O unit.
- Open the GV I/O chassis and remove the AJA Corvid 88 SDI I/O card.
- Insert the Mellanox ConnectX-5 card to replace the AJA Corvid 88 card.
- Close the GV I/O chassis and reconnect power to the GV I/O unit.
- Next, install software components manually according to instructions in Install software manually for GV I/O with IP option.