Set duplex LAN configuration

The duplex LAN configuration for the FT server has been done at the factory. There is no need to redo this configuration after installing your server. However, the procedure is provided here in case it is needed on the customer site.

To configure the duplex LAN, log on to the FT server using the factory default login, user Administrator, or the username and password you have set.

In this task you team network adapters, which correspond to the Ethernet connectors on the CPU/IO module rear panels. One team includes the top module's left-hand connector and the bottom module's left-hand connector. The other team includes the top module's right-hand connector and the bottom module's right-hand connector.

Start Device Manager.
Select a target Network Adapter. Right-click and select Properties from the menu displayed to show the Properties dialog box.
IMPORTANT: The display of Network Adapters may be duplicated as shown below, depending on the status at installation.
- Stratus emb-82576 2-Port Gigabit Adapter
- Stratus emb-82576 2-Port Gigabit Adapter
- Stratus emb-82576 2-Port Gigabit Adapter #2
- Stratus emb-82576 2-Port Gigabit Adapter #2
If such a case occurs, perform the following actions:
1. Delete all Network Adaptors from Device Manager.
2. Select Action Scan for hardware changes.
The display will be as follows when the actions are performed properly.
- Stratus emb-82576 2-Port Gigabit Adapter
- Stratus emb-82576 2-Port Gigabit Adapter #2
- Stratus emb-82576 2-Port Gigabit Adapter #3
- Stratus emb-82576 2-Port Gigabit Adapter #4
Select the Teaming tab in the Properties window. Check the Team with other adapters button and click New Team….
Enter team name Control Team and click Next.
Select the adapters that correspond to the two left-hand ports (when facing the rear panel) and click Next.
Select Adapter Fault Tolerance as a team mode. Click Next.
Click Finish.
Open the Modify Team dialog box as follows:
1. In Device Manager | Network Adapters, right-click Control Team and select Properties. The Properties dialog box opens.
2. Select the Settings tab.
3. Click Modify Team. A dialog box opens.
On the Adapters tab, do the following:
1. Select the adapter in the team that corresponds to port the top CPU/IO module, and click Set Primary.
2. Select the other adapter in the team and click Set Secondary.
Click OK and OK to close dialog boxes.
Repeat steps to create another team as follows:
- Name the team FTP Team.
- Team the adapters that correspond to the two right-hand ports (when facing the rear panel) .
- Make primary and secondary.
Start a Command prompt to check the physical MAC address set on ipconfig/all.