Other Topic Library Versions

K2 Central Storage setup and manual installation

Configure as follows:

  1. Disconnect network cables and unplug direct connections from K2 Central server to the K2 Summit clients.
  2. Disconnect the AC power to K2 Central and take out the front drives.
  3. Insert the USB thumb drive, load Acronis, and create a recovery image of the K2 Central.
  4. Reinsert the front drives and power on the K2 Central server.
  5. Configure the Control and FTP networks on the K2 Central server.
  6. Update hosts files and add to domain.
  7. Procure the 4.7.2_B50774_K2_Central SNFS software and install it manually. Then, reboot the K2 Central server.
  8. Procure the K2 Central software and install it manually on the K2 Central server.
  9. Install Discovery Agent, and select K2 Server as the server type.
  10. If the system is added to a domain, authenticate DHCP on the K2 Central as follows:
    1. Type DHCP in the Start menu.
    2. Open the DHCP application and authenticate the address.
  11. On the K2 Central desktop, run Storage Initializer to create a new file system. Then, reboot the K2 Central server.
  12. After initializing storage, run the K2 Central Config to set the number of FTP streams for K2 Central server to 10.
  13. Share the V: drive of the K2 Central, and create an EDIUS folder on the V: drive.
  14. If the GVAdmin password was changed, update the following file on the K2 Central server:

    C:\Program Files (x86)\Grass Valley\STRATUS Summit Service\Atlas.Service.Summit.ServiceHost.exe.config

Parent topic: K2 Central Storage configuration

Copyright © 2016 Grass Valley Canada. All rights reserved. GV STRATUS 4.5 gvtp_20160506_02:08:04