Editing segments

When you edit a segment, you change the length of the viewable asset by changing the Mark In and Mark Out points of the segment.

Double-click on a segment in the Segmentation panel.
The segment displays in the Source Viewer. The segment on the scrub bar appears in light blue to indicate that the segment is editable.
Navigate to the desired starting point using the scrub bar, and click the Mark In button. ( I)
Navigate to the desired end-point using the scrub bar, and click the Mark Out button. ( O)
Trim Asset is enabled when the asset has a mark-in or mark-out point. It is disabled if the asset does not have a mark-in or mark-out point.

Note: If a clip is a part of Dyno record train sequence, Mark In and Mark Out points should not be set beyond the limit of the guard band, as configured for the record train sequence.
Press the Esc key on your keyboard.
Your changes are saved to the segment.

The scrub bar of the Source Viewer turns back to dark blue to indicate that the segment is no longer editable.

The Segmentation panel displays the new duration, mark in, and mark out points for the segment.

You can also change Mark In and Mark Out points in the Inspector panel.