Create a subclip
Imported MXF clips must be conformed before you can create subclips.
- Load an asset into the Viewer.
-
Navigate to the desired starting point using the scrub bar,
and click the Mark In
button.
(
I)
-
Navigate to the desired end-point using the scrub bar, and
click the Mark Out
button.
(
O)
Trim Asset is enabled when the asset has a mark-in or mark-out point. It is disabled if the asset does not have a mark-in or mark-out point.
Note: If a clip is a part of Dyno record train sequence, Mark In and Mark Out points should not be set beyond the limit of the guard band, as configured for the record train sequence. -
Right-click on the scrub bar and select Create
Subclip. (
F4)
The New Subclip dialog box opens.
- Enter a name for the subclip.
- Navigate to the location to save the subclip.
- Click OK.
