Creating a subclip
- Load an asset into the Inspector.
-
Navigate to the desired starting point using the scrub bar,
and click the Mark In
button.
(
I)
-
Navigate to the desired end-point using the scrub
bar, and click the Mark
Out button.
(
O)
Note: If a clip is a part of Dyno record train sequence, Mark In and Mark Out points should not be set beyond the limit of the guard band, as configured for the record train sequence. -
Click on the Actions button and select
Media | Create
Subclip.
The Create Subclip dialog box opens.
- Enter a name for the subclip. If not, subclip is appended to the asset name by default.
-
Navigate and select a location to save the subclip.
Note: The last path from the previous subclip operation is automatically remembered as the starting point to save subsequent subclips. If there was no prior subclip operation, the starting path is automatically the same with the loaded asset.
- Click Create.
