Recording on ChannelFlex channels

If quota is configured on the K2 system bin, ensure you have enough disk space before recording assets.
It is recommended to set the quota on a destination bin to at least 2GB. Records will not begin if there is less than 1GB of free space remaining in the destination bin.

When your K2 system channel is configured for ChannelFlex Multi-Cam, two record inputs are available for the channel.

Launch a Channel Panel that contains ChannelFlex channels, or add ChannelFlex channels to the Channel Panel. The timecode control, transport controls, and slider bar operate both record inputs at the same time.
Do one of the following record operations:
- Record using crash record.
- Record using new clip.
Record operations are similar to those on a channel that is not configured for ChannelFlex.

A channel configured for ChannelFlex Multi-Cam is a record-only channel so you cannot load assets into the channel.

While recording, if the bin in which a growing asset exists reaches its quota, the clip will be forced to stop recording but will remain in the bin.