Aspera Node Service |
Setting for the Aspera Node Service to support FASP
transfer protocol in export workflow triggered by GV STRATUS Rules. This setting specifies
the URL of the Aspera web service on either a Windows or Linux server.
The convention must be http://<IP address of local Aspera Node
Service>:<port number>. Port number is typically
9091. |
Linux Mounted Path |
Specifies the base part of the UNC path to be stripped
for the relative path of an Aspera job order. The Data Mover Engine must strip the
base part to make the UNC file path in the Aspera job relative to the Linux mount
point. Leave this setting empty if your Aspera server is on a Windows
system.
|
Aspera User Account |
The user account and credential to access the Aspera Node Service. For an Aspera server
running on the Linux system, enter the user name and password that have been
configured under Linux with the asnodeadmin
command.
|
Maximum Concurrent
Transfers |
Limits the number of
simultaneous transfers performed by the Data Mover engine. Use to balance
resource load on the system hosting the engine.
The number of maximum concurrent
transfers can be monitored in the Resource Monitor of GV STRATUS Control Panel. |
Save |
Restarts the Data Mover engine and
applies changes.
Note: The device status can be monitored in the Resource Monitor of GV STRATUS Control Panel.
|
Cancel |
Reverts to previously saved
setting. |