Transferring an asset from a remote site
Make sure no other asset with the same name exists in the local
destination folder. If there is, rename the local asset before starting the remote asset
transfer or select another local destination folder.
- In Navigator, browse a remote GV STRATUS site and load a remote clip into Inspector.
- If you want to transfer only part of the asset, in Inspector set Mark In and Mark Out points to define the portion you want to transfer.
- In Inspector, click Actions | Copy To. A Copy To dialog box opens.
-
Select one of the following:
- Entire Asset: Copies the entire asset from the remote site to the local site.
- Partial Asset: Copies the portion of the asset between Mark In and Mark Out points from the remote site to the local site.
- Select the destination on the local GV STRATUS to which the asset is going to be copied.
- Click OK.
The asset is copied from the remote site to the local site. Progress is reported in the Monitors Jobs List.
Preservation of asset metadata after the remote transfer is as follows: