Using mark-in and mark-out points
- Navigate to the desired starting point using the scrub bar, and click the Mark In button. ( I)
-
Navigate to the desired end-point using the scrub bar, and
click the Mark Out
button. (
O)
Trim Asset is enabled when the asset has a mark-in or mark-out point. It is disabled if the asset does not have a mark-in or mark-out point.
Note: If a clip is a part of Dyno record train sequence, Mark In and Mark Out points should not be set beyond the limit of the guard band, as configured for the record train sequence. - To clear a mark-in or mark-out point, click the drop-down arrow by the respective button and select Clear Mark In ( Shift + I) or Clear Mark Out. ( Shift + O)
- To navigate to a mark-in or mark-out point, click the drop-down arrow by the respective button and select Goto Mark In ( Ctrl + I) or Goto Mark Out. ( Ctrl + O)