Acronis 11.5: Restoring from a system-specific recovery disk image on E: Type III

This task applies to the Type III FT Server model. Use this task to restore a server using an image made from that particular server.

Disconnect the AC power cabling from the top and bottom CPU/IO module.
In top CPU/IO module, leave drive 0 in slot, remove all other drives.
Provide AC power to top CPU/IO module.
Perform the steps in this procedure on the top CPU/IO module.
Make sure that media access is stopped and that the system on which you are working is not being used.
Connect the USB flash drive with the NEC-FT image to the USB port.
Startup and in BIOS setup disable OS Boot Monitoring. Refer to related topics in this Topic Library.
Do the following:
1. Insert the Acronis 11.5 WinPE Recovery CD.
2. Restart the machine. If there is a problem restarting, hold the standby button down for five seconds to force a hard shutdown. Then press the standby button again to startup.
The system boots from the Recovery CD. The Acronis program loads.
On the Acronis Rescue Media page, do the following:
1. Use the keyboard arrow keys to select Acronis Backup and Recovery 11.5 (64-bit...) and then press Enter.
2. Wait while Acronis fully loads.
On the Acronis Backup and Recovery page, select Recover. The Recover Data page opens.
On the Recover Data page, under What to Recover page, select Select Data. The Data to Recover Selection dialog box opens.
On the Data to Recover Selection dialog box, do the following:
1. Select Browse.
2. In the tree view, select the USB drive that contains the NEC-FT disk image.
3. Click OK.
On the Archive View tab, your backup name is listed.
On the Archive View tab, select your backup.
Under Backup contents, do the following:
1. Select MBR.
2. Select Basic. This selects all drives.
3. Click OK.
The Data to Recover Selection dialog box closes.
On the Recover Data page, click OK. The restore process begins.
On the My Recovery Details page, select the Progress tab to view the progress. The image loads in approximately 9 minutes.
When the data is successfully restored, click OK.
Close all Acronis pages and the Acronis main window. The machine restarts automatically.
Remove the recovery media while the machine is shutting down.
Wait until startup processes are complete on the top CPU/IO module. Leave the module running.
On the bottom CPU/IO module, connect AC power cabling. The module starts up.
Restart and in BIOS setup enable OS Boot Monitoring. Refer to related topics in this Topic Library.