Other Topic Library Versions

Marking In and Out Points

Mark points are used to determine the length of a clip.



  1. Find the spot on the videotape where you want your clip to begin.
  2. Mark an In Point using any of the following methods:
    • Press I on your keyboard.
    • Click the Mark In button on the GV STRATUS VTR Ingest window.
    • Type the timecode in the In field.
    • Create a Mark In on the VTR.
  3. Play through the tape until you reach the point where you want the clip to end.
  4. Mark an Out Point using any of these methods:
    • Press O on your keyboard.
    • Click the Mark Out button on the GV STRATUS VTR Ingest window.
    • Use the up or down arrows to find the correct timecode.
    • Type the ending timecode in the Out field.
    • Create a Mark Out on the VTR.

Copyright © 2019 Grass Valley Canada. All rights reserved. GV STRATUS 6.8 gvtp_20190318_01:43:25