Domain GV STRATUS Control Panel configuration

Before configuring GV STRATUS Control Panel:

The entire system must be restarted in the following order so that the registry settings take effect:
- K2 systems
- All other servers
GV STRATUS servers and K2 Summit systems must be licensed.
K2 Summit system channels must be configured.
Grass Valley recommends the GV STRATUS Control Panel is only configured on the Core server.

Configure Control Panel as you would a normal GV STRATUS system, except for the following steps.

In some fields you must manually enter text rather than selecting from a list.
Select Core | STRATUS Core Service | Primary Site and do the following:
1. Set the Database Server to the core name and choose a site name.
2. Under Internal System Account, enter the domain.
Select Core | MDI and configure a Grass Valley Media Server MDI to your SAN.

The SAN name is arbitrary. Choose the name that you want to appear in the Navigator of GV STRATUS. Be sure to set the credentials to use the GVAdmin account on the fully qualified domain, such as GVDOMAIN.
Select Core | MDI and set up Generic FTP MDI, if applicable.
Select Applications | Ingest | Channel Setup and set the credentials to use the internal system/domain account.
Select Applications | RMI and select the K2 system to import clips into.

The K2 setting is the name you used for your Grass Valley Media Server MDI. After entering this you should be able to browse to the desired Default Import Destination.
Shut down the entire system.
Power up in the following order:
- FSM/K2 Manager (Log in before powering up K2 Summit clients.)
- K2 Summit systems (Verify AppCenter is functioning on each client before powering up other servers.)
- All other servers.
Finish configuration of other devices (such as EDIUS, XRE/Render Engine, NCS/GV STRATUS Rundown, Archive servers etc.) as needed.

Some reboots may be required.