Playing ganged channels in loop play
- Launch a Channel Panel.
- Load assets into channels so they are cued up and ready to play. You can load the same asset on all channels or load different assets on individual channels.
-
Click
the
Loop Playback button.
The gang is now cued in loop play mode, as indicated by the highlighted loop play button.
-
Click the
the
Play button.
(
W)
Loop play begins on the channels. When each clip reaches its end, it automatically starts to play again from its beginning.
-
Control loop play as follows:
- To pause loop play, click the Pause button.
- To resume loop play, click the Play button. When loop play restarts it begins at the point from which it stopped.
- To stop loop play when it reaches the end of the clip, click the Loop Playback button. Playout continues normally and stops at the end of the clip.
Spacebar = Play/Pause. Toggles between play and pause.
Parent topic: About playing clips in a Channel Panel
Copyright © 2011 - 2023 GVBB Holdings SARL and Grass Valley USA, LLC. All rights reserved. Specifications are subject to change without notice. GV STRATUS 7.0 gvtp_20231124_15:10:36