If GV STRATUS security is
enforced, your credentials must give you adequate permissions. You can only view
assets with read permissions, and edit assets with write permissions. If read
permissions are denied on specific assets, those assets will not be available for
viewing.
When you trim an asset,
you change the length of the viewable asset, restricting it to the material
between the Trim In and Trim Out points. The material outside the trim marks is
not deleted. It remains on disk but is not viewable. To use the Trim Asset
operation, you must be logged on with a user account to which the Trim Rights
role is assigned. If the role is not assigned, the Trim Asset operation is not
available.
-
Load the asset into
the Inspector.
-
Navigate to the desired starting point using the scrub bar,
and click the Mark In
button. (
I)
-
Navigate to the desired end-point using the scrub bar, and
click the Mark Out
button. (
O)
Trim Asset is
enabled when the asset has a mark-in or mark-out point. It is disabled if
the asset does not have a mark-in or mark-out point.
Note: If a clip is a part of Dyno record train sequence, Mark In and Mark
Out points should not be set beyond the limit of the guard band, as
configured for the record train sequence.
-
Click on the Actions drop-down arrow, and select Media | Trim Asset.
The Confirm Trim dialog box appears.
-
Select the Do not ask again checkbox to prevent
recurring display of the Confirm Trim dialog box.
-
Click Trim to confirm the trimming of the asset.