Creating a playlist
-
Open the
Playlist Editor as follows:
-
Do one of the following:
- Right-click a bin on the K2 Summit system and select New | Playlist.
- Right-click in the empty space of an Asset List and select New | Playlist.
- Select an asset or select multiple assets (Ctrl + Click) in an Asset List and then right-click and select New | Playlist from Clips. When you use this option assets are added to the playlist in the order selected.
A New List dialog box opens.
-
Enter the name of your playlist and select the K2 system and
channel on which you are creating your playlist, then click
OK.
The Playlist Editor opens.
-
Do one of the following:
-
In a K2 bin in
Asset List , select an asset and drag it to the Playlist Editor panel.
The asset displays.
If needed, you can also drag it to the Inspector panel.
- To preview the asset, click the Play button or use the appropriate transport controls.
-
Drag the asset if you want to rearrange the playlist
in the lower section of the
Playlist Editor.
The asset is now referred to as an event in the Playlist.Note: If you leave the asset loaded in the Inspector and make additional changes, such as changing the mark-in or mark-out points, these changes are not reflected in the Playlist Editor unless you drag the asset to the Playlist Editor again. - Repeat above steps to add additional events.
- In the panel, use the toolbar buttons to modify events.
To play the Playlist, use the transport controls in the Playlist Editor's channel.
Parent topic: The Playlist Editor tool
Copyright © 2011 - 2023 GVBB Holdings SARL and Grass Valley USA, LLC. All rights reserved. Specifications are subject to change without notice. GV STRATUS 7.0 gvtp_20231124_15:10:36