Only systems with proxy on the K2 SAN
require this process. Use SiteConfig to install software on the
GV STRATUS server
with role of Proxy Server that is attached to the K2 SAN.
- The server on
which you are installing software must be in the SiteConfig system
description and communicating on the control network.
- The server on
which you are installing software must have its credentials set in
SiteConfig to allow access.
-
Verify the
SiteConfig roles currently assigned to the server. If the roles are not correct
for your system design, add or remove roles accordingly. Roles are as follows:
- GV STRATUS
Proxy K2 SAN Server
- GV Log Manager
- StorNext File
System Client
-
Add the server to a deployment group, such as the GV STRATUS deployment group.
-
Add the following
files to the deployment group:
- GrassValley_CoreServer_x.x.x.cab, which contains
the following cab files that apply to this device:
- GrassValley_STRATUS_HttpProxyServer_x.x.x.cab
- GrassValley_LogManager_x.x.x.cab
- GrassValley_STRATUSClient_x.x.x.cab.
- For K2 9.8.x systems; use GrassValley_K2system_x.x.x.cab, which contains
the following cab files that apply to this device:
- GrassValleyK2Server_x64_9.8.x.x.cab
- SNFS_x64_4.7.x.xxx.cab
- For K2 10.x systems; use GrassValley_K2Plus_x.x.x.cab,
which contains the following cab files that apply to this device:
- GrassValleyK2Server_x64_10.x.x.cab
- SNFS_x64_6.0.x.xxx.cab
Refer to
release notes for version numbers.
-
Do the SiteConfig
Check
Software operation on the server.
Note: If an "Unable to copy ... to
target" error appears for a device that has the Grass Valley Embedded Security
solution, apply the Embedded Security solution
one-time initial deployment process to the device. After the one-time process is
complete the error does not appear and it is no longer necessary to put Embedded Security in Update mode.
-
Verify that deployment tasks are
set to
Install
for the files listed above.
If a WFRegMon install task
appears, install it as well. It is required to support Grass Valley software
installers. There is no uninstall task.
-
Deploy software to the server.
-
Restart as prompted.
Next, use K2Config and set up the Proxy server on
the K2 SAN.