Restoring from a system-specific recovery disk image on E: Dell server
Use this task to restore a server using an image made from that particular server. If restoring from a generic factory default image, do not use this task.
- Make sure that media access is stopped and that the system on which you are working is not being used.
- Connect all motherboard NICs to LAN connections.
- If you have not already done so, connect keyboard, monitor, and mouse.
-
Do the following:
- Insert the Recovery Flash Drive.
-
Restart the machine.
If there is a problem restarting, hold the standby button down for five seconds to force a hard shutdown. Then press the standby button again to startup.
The system boots from the Recovery Flash Drive.The Acronis program loads. -
On the Acronis Rescue Media page, select Acronis Backup and Recovery 11.5
(64-bit...)
The Acronis Backup and Recovery page opens.
-
On the Acronis Backup and Recovery page,
select Recover.
The Recover Data page opens.
-
On the Recover Data page, under What to
Recover page, select Select
Data.
The Data to Recover Selection dialog box opens.
-
On the Data to Recover Selection dialog box,
do the following:
- Select Browse.
- In the tree view, expand the Local Folders node.
- Select the USB drive that contains the FT disk image.
- Click OK.
On the Archive View tab, your backup name is listed. - On the Archive View tab, select your backup.
-
Under Backup contents, do the following:
- Select C: and D:.
- Click OK.
The Data to Recover Selection dialog box closes. -
On the Recover data page, under Where to
recover, verify the following:
Recover to: Physical machine Clear all Recover the 'NTFS' partition with MB size to... Properties: System Reserved ..Size:....MB ..Letter: D Clear Disk 1/NTFS (D:) Recover the 'NTFS' partition with GB size to... Properties: NTFS ..Size:...GB ..Letter: C Clear Disk 1/NTFS (C:) -
On the Recover Data page, click OK.
The restore process begins.
-
On the My Recovery Details page, select the
Progress tab
to view the progress.
The image loads in approximately 9 minutes.
- When the data is successfully restored, click OK.
-
Close all Acronis pages and the Acronis main window.
The machine restarts automatically.
- Remove the recovery media while the machine is shutting down.
Parent topic: Working with GV STRATUS servers
Copyright © 2011 - 2023 GVBB Holdings SARL and Grass Valley USA, LLC. All rights reserved. Specifications are subject to change without notice. GV STRATUS 7.0 gvtp_20231124_15:10:36