Configuring RAID network and SNMP settings - Basic
- Fibre Channel cable(s) must be connected
- Ethernet cable(s) must be connected
- Power must be on
- Fibre channel cable(s) must be connected
- Power must be on
- IP address
- Subnet mask
- Gateway Address
- SNMP trap destinations
For K2 RAID, network and SNMP settings are set and stored on the RAID controller module, so the combined RAID storage devices, including the optional Expansion chassis, exist as a single entity on the control network.
The RAID storage device is configured by default for the SNMP community name “public”. If your site’s policies require using a different SNMP community name, contact your Grass Valley representative.
Next, bind disk modules.