Working with Loudness Logger and Loudness Analyzer

Using iControl Solo > Detailed Directions > Working with Loudness Logger and Loudness Analyzer

Opening Loudness Logger

Opening Loudness Analyzer

Specifying a Location for Saving Loudness Data

Logging an Audio Stream’s Loudness Data

Stopping a Loudness Log Recording

Configuring General Loudness Analyzer Settings

Opening a Loudness Log File in Loudness Analyzer

Configuring Loudness Analysis Parameters

Zooming into Loudness Analyzer’s Data Plot

Generating a Loudness Analysis Report

There are several tasks you can perform related to both logging and analyzing loudness data in iControl Solo. Certainly, before you do anything else, you must make sure your system is properly configured. You must also make sure you log before you analyze. While the sequence of these tasks may seem obvious, the sequence of other required tasks may not be. The following is an approved workflow for configuring, logging, and analyzing loudness data in iControl Solo.

Logging and analyzing loudness
1.	Open Loudness Logger (click HERE).
2.	Specify a location in your local file system where you would like loudness data to be saved (click HERE).
3.	Log loudness data for the desired audio stream (click HERE).
4.	Stop the loudness log recording (click HERE).
5.	Open Loudness Analyzer (click HERE).
6.	Configure general Loudness Analyzer settings (click HERE).
7.	Open a loudness log file (click HERE).
8.	[OPTIONAL] Zoom into Loudness Analyzer’s data plot (click HERE).
9.	[OPTIONAL] Configure loudness analysis parameters for this data plot (click HERE).
10.	[OPTIONAL] Generate a loudness analysis report (click HERE).


See also:
For more information about:
• Logging and analyzing loudness data, click HERE.
• Loudness Logger, click HERE.
• Loudness Analyzer, click HERE.
• Loudness Logger and Loudness Analyzer, refer to the Loudness Analyzer User Manual, available from the Documentation Library section of Grass Valley’s website.