Assigning Sources to a Comparison Group
Assign sources to a comparison group when you would like to increase the number of probed sources in a comparison.
REQUIREMENTS: |
Make sure you meet the following conditions before beginning this procedure: |
• You have opened Audio Video Fingerprint Analyzer ( click HERE). |
• There are currently no comparisons underway for the comparison group you would like to edit. |
• [RECOMMENDED]: You are performing this procedure as a task within the context of an approved workflow ( click HERE). |
1. On the Configuration tab, in the Fingerprint-generating devices area, click Refresh to update the list of available devices.
[ Graphic ]
System Response: The list of available fingerprint-generating devices refreshes.
2. If the folders representing the source cards are not expanded, expand them (by clicking the appropriate plus () symbols) in order to display the individual sources.
3. To assign a single source (at a time) to a comparison group, do one of the following:
• Click once on a source to select it, and then click, hold, and drag the source to the desired comparison group in the Fingerprint comparison setup area.
OR,
• Right-click once on a source, point to Add to comparison group, and then click the name representing the comparison group to which you would like to assign this source.
[ Graphic ]
System Response: The source appears under the comparison group in the Fingerprint comparison setup area.
System Response: An asterisk (*) appears next to the comparison group, indicating changes have been made that have not yet been saved.
4. To assign non-consecutive (as listed in the Fingerprint-generating devices area), multiple sources to a comparison group, do one of the following:
• Click once on a source to select it, Ctrl‑<click> each additional source you would like to add, and then click and hold any of the selected sources and drag the entire selection to the desired comparison group in the Fingerprint comparison setup area.
[ Graphic ]
• Click once on a source to select it, Ctrl‑<click> each additional source you would like to add, right-click any of the selected sources, point to Add to comparison group, and then click the name representing the comparison group to which you would like to assign this selection of sources.
[ Graphic ]
System Response: The sources appear under the comparison group in the Fingerprint comparison setup area.
System Response: An asterisk (*) appears next to the comparison group, indicating changes have been made that have not yet been saved.
5. To assign consecutive (as listed in the Fingerprint-generating devices area) multiple sources to a comparison group, do one of the following:
• Click once on the top-most source you would like to add to the comparison group, Shift‑<click> the bottom-most source you would like to add, and then click and hold any of the selected sources and drag the entire selection to the desired comparison group in the Fingerprint comparison setup area.
[ Graphic ]
• Click once on the top-most source you would like to add to the comparison group, Shift‑<click> the bottom-most source you would like to add, right‑click somewhere in the selection, point to Add to comparison group, and then click the name representing the comparison group to which you would like to assign this selection of sources.
System Response: The sources appear under the comparison group in the Fingerprint comparison setup area.
System Response: An asterisk (*) appears next to the comparison group, indicating changes have been made that have not yet been saved.
6. Configure the desired audio channels on the new source as required (
click HERE).
7. Click Apply all to save comparison group changes.
[ Graphic ]
System Response: The asterisk (*) next to the comparison group name disappears, indicating the change to the comparison group configuration is saved.
[ Graphic ]
