How to create a physical router in SE Utilities to control a KX router
2. On the Configuration menu, point to Router and click Add Router.
3. Set the router name.
4. Set Router Host to NVCONFIG (default value).
5. Set protocol to NV Ethernet.
6. Set Primary Control Point to the KX IP address (for example, 10.6.6.50).
7. Leave Secondary Control Point blank.
8. Click Add to add Physical Level.
9. Set digit under # to match Physical level of KX router in XEdit (normally this would be 0).
10. Set Input Start, Input End, Output Start, Output End to match dimension of KX router. Input Start must be set to 1, Output start must be set to 1.
11. Click Save.
12. Go to System Management and select NV9000 node in left pane.
13. Click Write Configuration to NV9000 to send config to NV9000.
14. Click Restart Controller 1.
15. Wait until the NV9000 has finished rebooting.
System Response: You should see all accessible routers visible in Left pane.
16. Select KX router in left pane.
System Response: You should see cross point status in central pane. You can also test switching KX router crosspoints by using Take area.