Operating Interface > Key Concepts > Single Bus Window > Single Bus Window Common Tasks
 
Single Bus Window Common Tasks
 
 
 
To do this...
...do this...
Cycle the selected destination busses between locked and unlocked states.1
1. In the Destination area, in the row corresponding to the desired destination, click the button so it displays UNLOCKED to effect an unlocked state.
 
2. Click the button so it displays LOCKED to effect a locked state.
 
Select which levels are switched
1. In the Levels area, enable the buttons corresponding to all the levels for which you would like to enable switching.
 
2. The current source at the output for each level is shown in the Status column.
 
Select one or more groups of destinations
1. In the Destination area, click the Down arrow next to the list of destinations.
 
The Destination/Group Selection window appears.
2. If you would like to select a single destination, click the desired destination.
3. If you would like to select multiple destinations, click Select group, then either select the desired destinations by clicking on each of them or click Select group to select all of them.2
 
4. Click OK.
1 If part of a group is locked, the overall group will be unlocked; those that are unlocked do not change state.

2 If you would like to make this an anonymous group, click Anonymous group.