Shutting the system down
There are three modes to shut down the system:
- Exit to Startup screen
- Exit to Shutdown
- Exit to Maintenance
- Press the Shift button and then from the HOME screen or the CONFIG screen, tap the EXIT SoftKey. This is the first step in shutting down the K2 Dyno S Replay Controller in three different modes. The Confirm Exit panel opens. The default shutdown mode is the Startup screen.
-
To exit to Startup screen, do the following:
- Open the Confirm Exit panel, as instructed by the steps earlier in this procedure.
- Tap Cancel to abort the Exit command and return to the previous session.
- Tap Restart to continue to exit. The K2 Dyno S Replay Controller restarts accordingly and displays the Server list, ready to configure a new session.
-
To exit to Shutdown, do the following:
- Open the Confirm Exit panel, as instructed by the steps earlier in this procedure.
- Tap the SoftKey next to the Shutdown mode prompt until it displays Shutdown. When Shutdown is selected, the SoftKey to the left of the blue box changes to Shutdown.
- Tap Cancel to abort the Exit command and return to the previous session.
- Tap Shutdown to continue to exit. The K2 Dyno S Replay Controller powers off.
-
To exit to Maintenance, do the following:
- Open the Confirm Exit panel, as instructed by the steps earlier in this procedure.
- Tap the SoftKey next to the Shutdown mode prompt until it displays Maintenance. When Maintenance is selected, the SoftKey to the left of the blue box changes to Exit.
- Tap Cancel to abort the Exit command and return to the previous session.
- Tap Exit to continue to exit. The computer leaves the Dyno mode and the Windows operating system desktop is displayed.
- To return to the Dyno mode from the Windows operating system desktop, double-tap the Dyno S icon on the desktop.