Re-image K2 Dyno S Replay Controller

Do not do this task if:

  • You are upgrading a first generation K2 Dyno Replay Controller
  • You are upgrading a K2 Dyno S Replay Controller with an operating system image already at the version specified in this document in the Version Compatibility section

Do this task if:

  • You are upgrading a K2 Dyno S Replay Controller with an operating system image that is not at the version specified in this document in the Version Compatibility section.
  1. Determine your current operating image version and proceed if a re-image is required.
  2. If you have not already done so, procure the latest "K2 Dyno S Controller Installation and Service Manual".
  3. This document is available on the K2 Dyno software download page.
  4. Reimage the K2 Dyno Replay Controller. Follow instructions in "K2 Dyno S Controller Installation and Service Manual". Refer to the Service Procedures section entitled Restoring from a generic recovery disk image.

© 2014 Grass Valley USA, LLC. All rights reserved. Grass Valley is a registered trademark of GVBB Holdings S.a.r.l.