Effects settings

On the CONFIG screen, tap EFFECTS. The Effects panel opens.

To change the transition point, select one of the following Use guard band for transitions options:

Option	Description
Yes	Centers transitions at In and Out points, allowing video beyond the set points to be visible.
No	Ensures the transition is completed within the marked points of the clip. This affects the length of the playlist.

To change the transition duration for the Flying M/E and each of the five preset effects, do the following:

In the first column enter a number less than 2:00 seconds but greater than or equal to 2 frames.

In the second column make settings as follows:

Video+Audio	Applies the transition to both output audio and video.
Audio Only	Applies the transition to the audio while video cuts.
Video Only	Applies the transition to the video while audio cuts.

In the third column make settings as follows:

Dissolve	Creates a cross fade between the two consecutive events.
Matte	Creates a flash of the selected color between the two events in the list. The duration of the flash is determined by the effect duration. To select the color, tap the adjacent color box and choose a color from the palette.
Wipe	Creates a bar traveling from one side to another between two consecutive events. To configure wipe settings, tap Set. Set the bar to move from left to right or from top to bottom. Turn Reverse on to set the bar to move from right to left or from bottom to the top. You can also set bar softness, border width, and color.