Split audio editing in a playlist

Clips in the playlist must have guard band material.

Open a playlist in the PLAYLIST screen.
Select a clip and jog into the content.
The light green vertical bar indicates your position in the clip.
To pull up video from the next clip in the list up while the selected clip's audio continues, do the following:
1. Press Shift + Trim.
  Dark green areas in the vertical bar indicate guard band material at the top and bottom of the clip.
  
  Trim Video and Trim Audio buttons appear.
2. Select Trim Video.
3. Between the clip's in and out points, jog to the desired video end.
4. Press Out.
  The vertical bar splits below the out point, indicating the video pulled up from the next clip in the list. Also, a green arrow indicates the video pulled up and reports the length.
The audio plays for the original length of the selected clip, but at the video trim out point the video displayed comes from the next clip in the list.
Select another clip in the list and jog into the content.
To extend the audio from the previous clip in the list into the selected clip, do the following:
1. Press Shift + Trim.
2. Select Trim Audio.
3. Between the clip's in and out points, jog to the desired audio start.
4. Press In.
  The vertical bar splits above the in point, indicating the audio pulled down from the preceding clip in the list. Also, a blue arrow indicates the audio pulled down and reports the length.
The selected clip's video plays at the beginning of the clip, but the clip's audio does not play at the beginning. Instead the previous clip's audio continues to play until the audio trim in point is reached, when the selected clip's audio begins to play.

If trim points overlap, the trim points from the clip higher in the list take precedence.
To clear the audio trim, do the following:
1. Select the clip in the playlist.
2. Go to the top of the clip.
3. Press Shift + Trim.
4. With neither Trim Video nor Trim Video selected, press In.
The original in point is reset and the audio trim is eliminated.
To view split edit information and navigate, do the following:
1. Press Shift + Trim. Trimming information for the currently selected clip is displayed in the upper left corner of the screen.
  A white stairstep indicates split video and audio edits.
2. Press arrow keys to navigate to edit decision points.

You can also use the VGA expansion screen for these operations.