Other Topic Library Versions

Install DynoZoom software on a K2 Summit system

  • On a K2 Summit system that supports DynoZoom, the DynoZoom board in the K2 Summit system and the DynoZoom Frame must be connected via PCIe and the DynoZoom Frame must be powered on before the K2 Summit system is powered on.
  • On the K2 Summit system, Embedded Security must be in Update Mode.
  1. Power on the DynoZoom Frame, if you have not already done so.
  2. Power on the K2 Summit system.
  3. On the K2 Summit system, insert the USB Flash Drive you received with the upgrade kit.
  4. On the USB Flash Drive, find DynoZoom_x.x.x.msi, which is the DynoZoom software installation file.
  5. Copy the DynoZoom installation file to the K2 Summit system.
  6. On the K2 Summit system, double-click DynoZoom_x.x.x.msi. The setup program launches to install the DynoZoom software.
  7. Complete the setup wizard, accepting default settings.
  8. Restart the K2 Summit system.
  9. On the K2 Summit system, use Embedded Security Manager and leave the Update Mode. Embedded Security Manager now reports Enabled.
Note: Once DynoZoom software is installed, the DynoZoom Frame must be connected and powered on first whenever powering up the K2 Summit system.

Next, do final steps.


Copyright © 2019 Grass Valley Canada. All rights reserved. K2 Summit 10.1.2 gvtp_20191213_00:21:37