Other Topic Library Versions

Making Rack Slide Adjustments

After installation, binding may occur if the slide tracks are not properly adjusted. To adjust the tracks:

  1. Slide the chassis out approximately 10 inches.
  2. Slightly loosen the mounting screws holding the tracks to the front of the rails and allow the tracks to seek an unbound position.
  3. Tighten the mounting screws and check the tracks for smooth operation by sliding the chassis in and out of the rack several times.
  4. Tighten the front panel retaining screws once the cabinet is in place within the rack to complete the installation.

Copyright © 2019 Grass Valley Canada. All rights reserved. K2 Summit 10.1.2 gvtp_20191213_00:21:37