Other Topic Library Versions

Verify/upgrade switch firmware

Do not do this task if:
  • Your HP ProCurve 29xx series switch already has the current required firmware version.
Do this task if:
  • Your HP ProCurve 29xx series switch does not have the current required firmware version.

Refer to compatibility information earlier in these release notes for firmware version requirements.

  1. Telnet to the switch and login with the administrator username and password.
  2. At the switch console command (CLI) prompt, type the following, then press Enter: menu If prompted to save the current configuration, answer no (press the n key) to proceed. The main menu opens.
  3. From the main menu, tab to Command Line (CLI) and press Enter. The command prompt appears.
  4. Check the version of firmware on the switch. To do this, type the following, then press Enter: show flash Information is displayed similar to the following example:
    HP_iSCSI_switch1# show flash
    Image           Size(Bytes)   Date    Version
    -----           ----------  --------  -------
    Primary Image   : 6737518   07/25/08  T.13.23
    Secondary Image : 5886358   10/26/06  T.11.12
    Boot Rom Version: K.12.12
    Current Boot    : Primary
  5. Check the Primary Image Version and refer to compatibility information earlier in these release notes. If instructed to change the firmware on the switch, do so before continuing.

Copyright © 2019 Grass Valley Canada. All rights reserved. K2 Summit 10.1.2 gvtp_20191213_00:21:37