Installing the K2 system on the rack mount rails

  1. Pull the slide-out track section to the fully extended position.
    DANGER
    To prevent injury, two people are required to lift the K2 system. It is too heavy for one person to install in the rack.
    DANGER
    To prevent serious injury, ensure that the rack is anchored to the floor so that it cannot tip over when the K2 system is extended out of the rack.
  2. Push the chassis toward the rack until the chassis sections meet the locking bracket.
  3. Verify the cabinet is pushed fully into the rack.
  4. Insert and tighten the front panel retaining screws as shown in the previous diagram.

Copyright © 2020 Grass Valley Canada. All rights reserved. Specifications subject to change without notice. K2 Summit 10.1.3 gvtp_20200819_01:49:13