JavaScript must be enabled in order to use this site.Please enable JavaScript in your browser and refresh the page. Reorder adapters Adapters must be named correctly The control team must be created The team and loopback must be named If not already open, open Network Connections as follows: Open the Windows Network and Sharing Center control panel. Click Change Adapter Settings. Network Connections opens. Select Advanced, then Advanced Settings… On the Adapters and Bindings tab, order adapters as follows: On a Dell system with four adapters only, the specified order is as follows Control Connection FTP-Streaming Connection Unused Connection 1 Unused Connection 2 On a Dell system with four adapters and a 10 Gig network interface card installed, the specified order is as follows Control Connection FTP 10G Connection Unused Connection 1 Unused Connection 2 Unused Connection 3 10G Click OK to close and accept the changes. Close Network Connections. If continuing with network configuration, next set power management settings. Parent topic: Restoring network configuration
